PVC Machine Operator
Johns Manville
- Edison, NJ
- Permanent
- Full-time
- Supports and promotes safe practices and environmental commitments in alignment with company commitments, policies, and compliance requirements.
- Show initiative in supporting safety, plant wide. Participate on committees as required.
- Ensures that all Housekeeping & 5S areas of responsibility have been completed before end of shift and keeps equipment, work areas and other prescribed areas clean and orderly at all times.
- Wears all required and proper PPE.
- Operates a lift truck or other material handling equipment in servicing production as required (must be properly licensed).
- Uses safe work practices and reports hazardous conditions at all times to supervisor.
- Complete computer-based training and all other programs needed to stay in compliance with company policy’s.
- Receives and follows verbal and written instructions from supervisor or leader. Prepares production reports as directed or required.
- Must be able to operate the comet and the table saw
- Take Off- Remove form PVC fittings from table saw and place them on the next table which is the band saw.
- Flip the PVC fittings at the table
- Trimming PVC fittings with hand scissors to the correct lengths
- Reports equipment malfunctions, operation delays, or product defects immediately to supervisor or leader.
- Conducts all Cut & Curl tasks independently and at set production rate Prepares production reports as directed or required.
- Performs molding operation for PVC fittings, on unit or line as directed. Inspect fittings for obvious defects-surface, thickness, other as directed- a beginning of shift, and throughout the production run.
- Operate Horizontal Band Saw & Small Mike Thermoformer
- Cross trained in either the 300 room, Inline, or Comet Floor Grinder start/stop
- Assist with Horizontal blade change
- Must be able to stand for long periods of time on cement floors
- Must be able to walk, stoop, kneel and climb ladders and staircases.
- Must be able to lift up to 50 lbs as required.