The Press Brake Operator will lay out materials per blueprint instructions. They also set up and operate Hydraulic Press Brake machines of various sizes from 230T to 400T to form various sizes and gauges of steel into transformer and voltage regulator tank components. In this function, you will: Set up forming dies and punches in the press brake. Enter part number information into the computer terminal. After forming a part and first-piece piece check, the operator makes the necessary corrections to the part program to adjust for variations in material. Position each piece against stops and form pieces to the required angle and bends. Check finished pieces against print for correct dimensions and adjust the press brake as needed. Work with another operator to aside completed parts to pallet. Develop computer programs for new parts. Minimum of 6 months of machining experience within a manufacturing environment No relocation benefit is being offered for this position. Only candidates within a 50-mile radius of the work location will be considered. Active-Duty Military Service member candidates are exempt from the geographical area limitation. A High school diploma or GED equivalent from an accredited institution Minimum of 6 months of previous Press Brake machine operation experience. Ability to work overtime when required. Ability to lift up to 50 LBS; bend, twist, grab, reach, stand, walk, push, pull, use both hands to lift and lower materials, and perform all other essential duties with or without reasonable accommodations.
